Pelgrim GVWC270L Notice D'utilisation page 157

Remote control the dishwasher
The dishwasher's network symbol
smartphone/tablet. You can use the ConnectLife app to monitor the dishwasher and change settings.
Remote start the dishwasher
To remote start the dishwasher, press
Close the door. The status light will flash slowly, indicating that remote start is activated.
In the ConnectLife app, select and start a program.
If the door is not closed within 2 minutes, the machine switches off.
NOTE!
The dishwasher can always be used without the app. When the dishwasher's control panel is
pressed, commands from the ConnectLife app are blocked for 10 seconds.
Pair more devices
Pair more devices/users with the dishwasher.
In the ConnectLife application, go to the »Add devices« menu and select the appropriate type of
device. Then scan the QR code (it can be found on the serial number plate of the appliance; you
can also enter the AUID/SN number manually).
Open the dishwasher door and press
On the dishwasher's control panel: Press and hold
on the display, after which the display starts counting down.
Deactivate/activate WiFi connection
After connecting the dishwasher to your local network, you can deactivate the WiFi connection. You
can then reactivate the WiFi connection to reconnect to the same network.
On the dishwasher's control panel: Press and hold
connection. Off appears on the display.
On the dishwasher's control panel: Briefly press
on the display.
Remove devices
Remove all connected devices/users.
On the dishwasher's control panel: Press and hold
3 seconds. UnP appears on the display, after which the display starts counting down.
Do you have questions? Please visit us at www.connectlife.io or contact us at hello@connectlife.io.
is shown on the display when the dishwasher is paired with a
and then . APP will flash on the dishwasher's display.
.
for 4 seconds to start connecting. P appears
for 8 seconds to deactivate the WiFi
to reactivate the WiFi connection. On appears
for 4 seconds, then press and hold for
21