5.1. Make sure the drain fitting is plugged securely and the cap
is in place. Start filling the pool with water. After about 1-inch of
water is on the bottom, stop filling and smooth wrinkles out of the
bottom of the pool. Pull the outer
wall out from the top edge, all
around the bottom of the pool,
90%
so that it fills evenly.
5.2. Continue filling the pool until
water level .
6.0 Disassembly and storage
WARNING: Do not let your children stand at downfold and face the water outlet
during the drainage. The water current may sweep your children.
WARNING: Pool should be stored at places where it is cool and dry, with no sharp
object surrounded, or no heavy objects lying above, which may cause damage to the
pool.
Step 1. If you have a filter pump,make sure that the electricty source to the filter
pump has been disconnected.
Step 2. Check to ensure that the out drain plug is firmly inserted on the inside of the
pool.
Step 3. Attach your garden hose to the drainage valve connector, and placing the
other end of the hose in an area where the water can drain safely,such as a storm
drain or street gutter.Remember that because water always finds its own level,the
end of the hose must be lower in elevation than the pool to ensure complete
drainage.
Step 4. If you have a filter pump, insert the stopper into the inlet and outlet fixtures,
on inside of pool, and then disconnect the filter pump hoses.
Step 5. Attach the drainage valve connector to the drain outlet by turning connector
in a clockwise direction.
Step 6. Open the out drain plug on the inside of the pool and the water will begin to
drain immediately.
Step 7. Disconnect the hose and drainage valve connector when finished.
Step 8. Replace the out drain plug on the inside of the pool.
Step 9. Be sure that the pool liner is completely dry before folding the pool for
long-term storage. Leaving the pool exposed to sunlight for a few hours will clean
and speed the drying process and make it easier to fold the pool for storage. (Never
attempt to fold or stow a pool that is not completely dry as this could lead to a
12
MSP-30103-V03