Denon TU-460 Mode D'emploi page 8

ENGLISH
FRONT PANEL
iwawid ol OkHz CHI
iy Cl) 0. 0 MHz & UMEMO|
30CH T STATION
DISPLAY SYSTEM
Fig. 4
DESIGNATIONS AND FUNCTIONS OF PANEL CONTROLS
0
@
POWER (Power ON/ OFF Switch)
The unit works 2-3 seconds after this switch is turned on.
TEN KEYS (Ten Key Buttons)
Used to specify numbers for Memory, Auto Memory and
Preset Call. Channels 1-30 can be specified using these
buttons.
Preset Call Setting Method
A station that has already been preset can be fetched by the
following method.
Pressing [, 21, CENTER ] in order fetches the station
present in memory for channel 12.
ENTER (Enter Button)
Used for setting Memory, and preset Call.
TUNING (Tuning Buttons)
Used to change the received frequency to a higher
frequency (UP) or a lower frequency (DOWN).
BAND (Band Button)
Selects between FM or AM.
TU-460L: Pressing this button changes the tuner from FM
to MW to LW, then back to FM, in that order.
ANTENNA (Antenna Switching Button)
Use this button to switch the antenna to receive a cable
station or a regular station.
The antenna modes can be stored in the memory.
AUTO MUTE/MANU (Tuning Mode Button)
This switches between auto and manual tuning.
Auto tuning: When the UP key is pressed, the radio is tuned
automatically to a higher frequency. Press the DOWN key
to tune to a lower frequency. Use this position to eliminate
noise when no signals or weak signals are being received.
Manual tuning: In this position, the radio can be tuned
manually.
TU-460L: Not available in this model, during reception of
LW only.
MEMORY (Memory Button)
Used to store the frequency of the station currently
received.
Pressing (MEMORY_], (0, [2 CENTER 1] in order stores the
station on channel 12 in memory. Up to 30 channels of
either FM or AM can be stored in memory.
19)
©
MEMORY (Memory Indicator)
This indicator lights when the MEMORY button @ is
pressed.
CHANNEL (Channel Indicator)
This displays the number of the channel at which the
station is stored.
DIGITAL FREQUENCY INDICATOR
Reception frequencies are digitally indicated with numbers.
The FM frequency unit is MHz; the AM frequency unit is
kHz.
SIGNAL (Signal Indicator)
This lights when a station can be received.
STEREO/MONO (Stereo/Mono indicator)
"STEREO" lights automatically when receiving a stereo
broadcast.
"MONO" lights when receiving a monaural broadcast or no
broadcast at all.
TUNING MODE (AUTO/MANUAL)
Pressing MODE @ causes "AUTO" and "MANUAL" to light
up alternately.
TU-460L: Pressing this button does not switch the tuner to
Auto Tuning Mode, during reception of LW
only.
SIGNAL (Signal-Strength Indicators)
The number of LEDs that light increases in correspondence
with the strength of the signal being picked up by the
antenna.
ANTENNA (Antenna Indicator)
The "NORMAL" or "CABLE" LED lights to indicate whether
in the normal or cable mode (controlled by key @).