Toshiba KT-4038 Mode D'emploi page 9

Auto Stop
The auto stop feature automatically disengages the tape transport and switches off the
unit when the end of the tape is reached in playback mode. Always press the [STOP] but-
ton @ to disengage the tape transport in fast-forward and rewind modes.
Notes: ¢ The above feature does not work when the [REVERSE MODE] selector @is set
at" CD".
Using the Graphic Equalizer
¢ The graphic equalizer enables the low, middle and high frequencies to be boosted or
reduced to change the overall sound as required.
e The three sliding knobs operate around frequencies of 100 Hz, 1 kHz and 10 kHz.
¢ Slide the knob in the + direction to increase the volume around that frequency and
in the — direction to decrease it.
Care and Maintenance
To ensure the highest performance from your unit, keep
the entire tape path, including the playback head, pinch
roller, and capstan, completely clean.
= Clean the Tape Path
Open the cassette lid. Then dip a cotton bud into a little
alcohol, remove a excess alcohol from the bud, then
clean the entire tape path with the bud. During clean-
ing, take care to avoid scratching the head surface.
= Cleaning the Unit Housing
To clean the unit housing, use a soft, dry cloth. If dirt persists, use a soft cloth slightly
dampened with water. After cleaning, wipe the unit surface with a dry cloth.
Caution: Never use chemicals such as benzene or paint thinner for cleaning. Otherwise,
the case may be deformed or discoloured.
Notes and Precautions
™ To prevent possible trouble or physical deformation, avoid operating or leaving the unit
in places where:
e They will be in the path of direct sunlight. (Especially in a closed car.)
¢ They are subject to direct radiation or hot airflow from heating devices.
° They are subject to oily smoke or excessive moisture, as in a kitchen, etc.
® Do not place the unit or cassettes near highly magnetic materials. Do not leave them
on a radio, TV, or stereo equipment.
® Do not touch the unit with bare, wet hands.