Olympia A 6040 Mode D'emploi page 21

If Problems Occur
If Problems Occur
Clearing Pouch Jams
If you inadvertently feed the laminating pouch into the
angle, or if the rollers are soiled with too much residual adhesive, or if
you try to laminate unsuitable materials, laminating pouches can jam
inside the laminator.
The laminator's sensors check for correct infeed of the laminating pouch-
es and immediately put the rollers into reverse when they detect a jam.
Then the laminator runs in reverse and ejects the laminating pouch at the
.
infeed
9
In case of problems, you can also manually reverse the rollers by press-
ing the
AUTO / REVERSE button
1. Press and hold the
into reverse.
CAUTION! Risk of burns through hot laminating pouch. When
the laminating pouch is ejected after lamination, it is extremely
hot. Only remove the ejected lamination pouch holding it at the
cooled end.
2. Carefully pull the laminating pouch out of the
tor.
3. Only release the
pouch has been fully ejected at the
After a pouch jam, always clean the laminator. Clean the laminator
as described in the section Regular Maintenance and Ser-
vice.
20
7
AUTO / REVERSE button
AUTO / REVERSE button
G
infeed
.
. The laminator goes
7
infeed
when the laminating
7
.
infeed
9
at an
9
of the lamina-
9