Bosch ADS181 Consignes De Fonctionnement/Sécurité page 8

BM 2610034437 03-14_ADS181 3/27/14 12:08 PM Page 8
Disconnect battery pack
W RNING
from tool before making
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
INSERTING BITS
Move reverse switch lever to the center "OFF"
position. Rotate the chuck sleeve counter-
clockwise viewing from chuck end, and open
chuck to approximate drill bit diameter. Insert
a clean bit up to the drill bit flutes for small bits,
or as far as it will go for large bits. Close chuck
by rotating the chuck sleeve clockwise and
securely tighten by hand (Fig. 2).
Do not use the power of the
W RNING
drill while grasping chuck
to loosen or tighten bit. Friction burn or hand
injury is possible if attempting to grasp the
spinning chuck.
Assembly
FIG. 2
CHUCK SLEEVE
DRILL BIT
-8-
BIT HOLDER
SCREWDRIVER BIT