Siemens VS07 Serie Mode D'emploi page 14

When the work is done
*
To release the connection, press the unlatching sleeve
and pull the telescopic tube out.
* Depending on equipment level
26
en Changing the dust bag
Replacing the dust bag
If the dust bag change indicator in the cover is
completely yellow when the floor tool is lifted off the
floor and the highest suction setting is selected, the
dust bag must be replaced even if it should not be
completely full yet. In this case it is essential to change
the dust bag due to the type of material it contains.
The nozzles, suction pipe and flexible hose should not
be blocked, as this will also trigger the dust bag
change indicator.
Open the cover by moving the locking lever in the
direction of the arrow.
Seal and remove the MEGAfilt ® SuperTEX dust bag by
pulling on the tab as shown.
en
27