Publicité
Step
Step 30
Carefully stand your unit upright and position in its fi nal location.
å
NOTE: To lift a corner of the unit, rotate the ADJUSTABLE GLIDE to the left. To lower a corner,
å
turn the ADJUSTABLE GLIDE to the right.
Turn the ADJUSTABLE FEET (25E) downward until they touch the fl oor.
å
IMPORTANT: The ADJUSTABLE FEET should not extend beyond the bottom edges of the
å
ADJUSTABLE GLIDES.
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as
å
shown in the diagram. If it isn't, loosen the mounting screw to slide it against the stops. Then
tighten the mounting screw.
Fasten the LARGE DOOR (L2) to the LARGE END (B2) as shown in the lower diagram. Use the
å
screws in the HINGES. You should start each SCREW a few turns before completely tightening
any of them.
Fasten a PULL (97K) to the LARGE DOOR (L2). Use two SILVER 3/4" MACHINE SCREWS (20S).
å
See the next step for DOOR adjustments.
å
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
Turn the ADJUSTABLE FEET
downward until it touches the fl oor.
Page 36
Floor
25E
R
411572
LARGE DOOR ON RIGHT
L2
B2
20S
SILVER 3/4" MACHINE SCREW
(2 used for the PULL)
www.sauder.com/services
97K
Publicité
