Publicité
Step
Step 25
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (K) and lay it over your unit.
Make equal margins along all four edges of the BACK (K). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (K) to your unit using the NAILS (1N).
å
Fasten the FOOT BASES (24E) to the BOTTOM (F2). Use eight
å
SILVER 5/8" FLAT HEAD SCREWS (23S). Then, push the
FEET (25E) into the FOOT BASES (24E).
NOTE: Turn the adjustable ends of the ADJUSTABLE FEET
å
completely in. Final adjustments will be made after the unit is
standing upright.
Fasten the METAL BRACKET (4G) to the BOTTOM (F2)
å
and FRONT SKIRT (Q). Use two BLACK 9/16" LARGE
HEAD SCREWS (1S).
SILVER 5/8" FLAT HEAD SCREW
(8 used for the FOOT BASE)
25E
Turn completely in.
These holes must be here.
www.sauder.com/services
23S
NAIL
(72 used for the BACK)
24E
F2
Q
4G
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Before fastening the BACK, push the
SAFETY STRAP through the hole.
1N
K
BLACK 9/16" LARGE HEAD SCREW
(2 used for the ANGLE BRACKET)
411572
LARGE DOOR ON RIGHT
These holes must
line up over the
UPRIGHT (D2).
1S
Page 31
Publicité
