Publicité
®
R&S
RT-ZZ80
Signal pin, solder in, and ground pin, solder-in
User Manual 1409.7689.02 ─ 02
Connecting the Probe to the DUT
Using two solder-in pins for ground and signal,
the R&S RT-ZZ80 is soldered directly into the
circuit.
The pins can be exchanged on the probe and
can remain in the circuit. Thus, you can plug
the probe on different test points.
Use tweezers to insert the solder-in pins into
the sockets on the probe, and then cut to the
appropriate length. Keep the pins as short as
possible.
The fine wires on this adapter are best suited
to make secure contact with small contact
points, such as SMT components or IC pins.
Alternatively, the signal pin has a solder tail for
direct soldering of wires.
Distance range:
0 mm to 20 mm (0 mil to 800 mil)
19
Publicité
