Ariens BL 300 Livret D'utilisation Et D'entretien page 33

Ariens
INSTRUCTIONS FOR MOTORHOE ASSEMBLY
The machine is packed in a box of the following dimensions :
WIDTH: 80 cm.
◊
•
Take the machine out of the carton box.
•
Fit the two tillers to the main shaft using the delivered screws and nuts.
•
Fit the rear spur in its place using the delivered bolt and both pins which are on the spur holder.
•
Fit the handlebar on the support:
- The model with the vertical adjustment is fitted with two screws and nuts already fitted on the handlebar.
- The model with the full-side adjustment (rack, wheel system) is fitted with the parts already mounted on the handlebar holder.
•
The front wheel holder is fitted to the frame by means of two pins with cotter and spring. The small wheel has to
be fitted on the holder through screw and nut. To put the small wheel in the requested position pull outwards till the pin is
completely inside the buttonhole (see picture n.7).
•
Fit the two guard-extensions to the main tiller protections fitted on the body of the machine using the proper
screws and nuts. The protection guards should reach a width of 60 cm according to CE norms.
•
To make the transport easier it is possible to keep the handlebar disassembled, by means of the two screws in
one version or by means of the thread bushing in the other one, that fix it to the handlebar holder.
33
HEIGHT: 70 cm.
◊
BL 300 / BL 350
LENGHT: 45 cm.
◊