Ravelli Infinity Plus 11 Serie Manuel D'utilisation Et D'entretien page 57

Connections
! IMPORTANT
Connection with external air intake
The stove has been designed for hermetic installations.
To make the connection with an external air intake, proceed as follows:
step action
Connect a 50 mm diameter pipe to the combustion air inlet pipe at the back of the stove. Note: the pipe must be no
1
more than 2 m in length.
The air vent must be installed in such a way that it can not be blocked.
Chimney connection
The chimney must be sized so as to guarantee the draught declared by the Manufacturer.
Electrical connection
The plug of the stove power cable must be connected only after installation and assembly has been completed
of the device, and must remain accessible after installation.
To perform the electrical connection, proceed as follows:
step action
1 Connect the power cord to the back of the stove.
2 Connect the plug of the power cord to the wall socket.
Schema elettrico KTR AIR
Electric scheme
Schema elettrico Scheda madre
Scheda OPZIONALE
per gestione
domotica
G2
S3
G4
S2
verde
bianco
S1
G1
G5
LEGENDA:
Sicurezze
Resistenza
T1 - Contatto Sportello fuoco
R1 - Resistenza
T2 - Contatto cassetto cenere
Sonde
T3 - Contatto serbatoio pellet
S1 - Sonda fiamma (K)
Use and maintenance manual Infinity Plus 11
The connections must be set up by a technician that is qualified and/or authorised by the
Manufacturer.
(configurazione ventilata o canalizzata singola)
NC NO
COM
G6
Vers. 03 del 22/03/16
Connessione OPZIONALE per
gestione domotica
NC NO C
G5 G5
G6 G6 G6
10 9 8 7 6 5 4 3 2 1
RETE ALIMENTAZIONE 220 V
Fase
Neutro
G2
R1
T1
T2
T3
T4
T5
G3
Rev.1 12/04/2018
Page 57 EN
LEGEND:
Safety devices
T1- Contact with fire door
T2- Ash drawer contact
T3- Pellet tank contact
T4 - Pellet safety
T5- Pressure switch
Motors
M1 - Infeed screw gear motor
M2 - Room fan
M3 - Fume exhaust system
M4 - Heat exchanger 1 fan
M5 - Heat exchanger 2 fan
Resistance
R1 - 250watt heaterSonde
Probes
S1 - Fume probe
S2 - External thermostat
S3 - Room probe
S4 - Rear or RRight Probe/
EXT. T.
S5 - RLeft Probe/EXT T.
General
G1 - Flow meter
G2 - Extractor revolution
reading encoder