EINHELL 44.191.42 Mode D'emploi page 10

Anleitung_BT_MG_160_KIT_SPK1:_
GB
6. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
6.1 Inserting the various tools (Fig. 2)
Before inserting a tool (and before each tool
change) switch of the drive unit and pull the power
plug.
1. Press the locking knob (8) and turn the collet
chuck until the bolt locks into place.
2. Undo the collet chuck nut (7).
3. Insert the required tool into the sleeve and tighten
the collet chuck nut (7).
6.2 Installing the flexible shaft (Figs. 2/3/4)
Unscrew the cover (9) from the front of the
equipment.
Undo the collet chuck nut (7).
Insert the internal schaft (a) of the flexible shaft
into the collet chuck (7).
Tighten the collet chuck nut (7).
Now tighten the ring (b) on the multi-tool.
7. Operation
Make sure that the drive unit is switched off.
Check that the mains voltage specified on the
rating plate of the power supply unit is the same
as your mains supply. Only then should you
insert the plug of the power supply unit into a
socket-outlet.
7.1. ON/OFF switch (Fig. 2)
Switch on the drive unit with the power switch (5).
7.2. Speed selector (Fig. 2)
The required speed can be set with the speed control
buttons (6).
Press the "+" button to increase the speed.
Press the "-" button to decrease the speed.
Refer to the display (10) for the set speed.
Set speed = Display x 1000
10
14.02.2008 14:43 Uhr
The correct speed depends on the tool used and the
type of material being processed.
7.3 Directions for use
With small milling cutters / grinding pins: Use a
high speed.
With large milling cutters / grinding pins: Use a
low speed.
Precision work / engraving: Hold the drive unit
like a pen.
Rough work: Hold the drive unit like a hammer.
7.4 Tips
Exert only moderate pressure on the workpiece
and allow it to be processed at uniform speed.
You will not finish your work sooner by exerting
heavy pressure. On the contrary, heavy pressure
will cause the drive unit to slow down or stop and
will overload the motor.
For your own safety, use a vise or screw clamp to
secure small workpieces.
8. Accessories (Fig. 5)
Description of the accessories:
11 Grinding head
12 Attachments for the grinding head
13 Whetstone
14 Clamping spindle for grinding and cutting-off
wheels
15 Cutting-off wheel
16 Sanding/grinding paper
17 Holder for felt polishing disk
18 Felt polishing disks
19 Grinding pins
20 Sleeve
21 Drill chuck key
22 Engraving pin
Cutting disks:
For cutting metal and plastic.
Insert the cutting wheel onto the clamping spindle.
Grinding pins:
In various grinding head shapes.
For grinding and deburring metal and plastic.
Grinding paper:
For grinding and deburring wood and plastic.
Polishing felt:
For polishing brass, tin, copper, etc. Also for use with
polishing pastes.
Seite 10