Hitachi DH 30PB Instructions De Sécurité Et Mode D'emploi page 21

External dia. Code No.
7/16"
944460
(11 mm)
31/64"
944461
(12.3 mm)
1/2"
993038
(12.7 mm)
9/16"
944462
(14.3 mm)
73/128"
944500
(14.5 mm)
11/16"
944463
(17.5 mm)
27/32"
944464
(21.5 mm)
2. Knock-in anchor (Striking only) (DH30PC)
Anchor Setter (for anchor setting)
(SDS-plus shank)
<Outer wedge type with the female screw>
A
nchor size
Overall Length
Code No.
<Inner wedge type with the headless screw>
A
nchor size
Overall Length
Code No.
Anchor setting adaptor
(for manual hammer)
Taper mode
Morse taper
(No. 1)
Morse taper
(No. 2)
A-taper
B-taper
W 1/4" W 5/16"
(6.3 mm) (8 mm)
10-15/64" 10-15/64"
(260 mm) (260 mm)
302976 302975
W 1/4" W 5/16"
(6.3 mm) (8 mm)
10-15/64" 10-15/64"
(260 mm) (260 mm)
302979 302978
Code No. Applicable drill bit
Drill bit
303617
(Taper
shank)
Drill bit
303618
(Taper
shank)
Taper shank adaptor formed A-
303619
taper or B-taper is provided as
an optional accessory, but drill
303620
bit for it is not provided.
6-19/64"
(160 mm)
303621
6-19/64"
(160 mm)
303622
English
7/16" (11 mm)
31/64" (12.3 mm)
1/2" (12.7 mm)
9/16" (14.3 mm)
73/128" (14.5 mm)
11/16" (17.5 mm)
27/32" (21.5 mm)
W 3/8"
(9.5 mm)
10-15/64"
(260 mm)
302974
W 3/8"
(9.5 mm)
10-15/64"
(260 mm)
302977
21