TEFAL 5 second Chopper Mode D'emploi page 5

Safety instructions
In order to get an optimal result, fill in half the container with pre-cut pieces without skin.
Do not use the appliance with meat with bones, you would definitely damage the blades.
Safety information
This appliance must be used only on the TEFAL® 5 SECOND CHOPPER 900ml.
This appliance should never be used by children or by people with a disability which would
prevent them from using it safely.
This appliance is not a toy. Keep it out of the reach of children.
Use the appliance on a stable and dry working surface.
Avoid filling in more than half the container. - fig. B
Set the locking system when closing the bowl.
The high quality blades of the cutting rotor are extremely sharp. Be very careful to protect
your fingers when you use them. Gloves are recommended.
Always use the cutting rotors in the adapted container with the lid closed.
This appliance is conceived for solid ingredients.
Do not operate the appliance if :
- the container is empty
- the blades of the cutting rotor are damaged
- there is visible damage on the appliance or it is not functioning properly
- if the mechanism is blocked.
Always store the cutting rotors in their protective case, when you do not use the appliance.
This product is designed for household use and not professional use.
If it is used for professional purposes, the warranty will be void and no liability will be assumed.
Using
1. Remove all the parts from the box and clean them thoroughly by hand before using for the first
time. Please refer to the instructions under «Cleaning» section.
2. Place the container on a stable and dry working surface.
3. Remove the cutting rotor from its protective case.
4. Put the lifting aid on the table, it must be stable (otherwise just turn it). Hold the wing with one
hand and with the other hand hold the cutting rotor on the fixed wing and the blades in the same
position as the fixed wing (light green), then push the cutting rotor from the top on the lifiting aid.
It will lift up the herbs, garlic, chili from the bottom of the container and chop it very finely. Remove
lifting aid when using other ingredients. - fig. C
5. Place the cutting rotor in the container with the blades above one another to optimize the space
for the ingredients you want to chop. - fig. D, E
6. Cut the big ingredients such as carrots or onions in a piece shorter than the length of the blades
so that they will not block the blades of the cutting rotor.
7. Then place them in the container while making sure that the cutting rotor will remain straight.
8. Place the lid on the container making sure that the hexagon on the cutting rotor fits into the
recess in the lid.
9. Place one hand on top of the lid to hold the appliance down on the working surface. Then use
the other hand to grip the pull mechanism on the lid.