Publicité
Les langues disponibles
Les langues disponibles
English
6) Remove the top hinges (4 screws on each side) and lift off the doors. Remove
the middle hinges (3 screws) if necessary.
[Illustration 3]
Water Line B
[Illustration 4]
How to Reconnect the Water line (only applicable to Hb21fc75*)
1) Reinstall the cabinet side tubing (Water Line A, Illustration3) to the connector
by firmly pushing the tubing into the union as far as it will go. Follow the color
mark on the tube as seen in Illustration 1. Do not depress the end of the union
when inserting the tube. Replace the black locking clip.
2) Repeat at the back panel of the union (Water Line B), again making sure that
the tubing is inserted as far as it will go. Follow the color mark on the tube.
Replace the black locking clip.
WaRnInG: Be careful not to bend or distort the tubing. Also check to ensure
there are no foreign objects in the connector, union, or tubes.
left french Door Removal and Installation
1. First remove the top hinge cover as below.
2. Disconnect the wire cable connector and ground wire from the unit.
3. Remove the middle hinge, if needed.
4. Re-install the door in the reverse order.
When lifting the hinge as it separates from the door, be careful it doesn't lean
forward and fall, causing bodily harm or damaging the door.
7
Water
Line A
Connector
Screw B
Electrical
Conectors
Hinge
Screws
Disconected the cable,crew out the earth line.Disconected the
Disconected the cable,crew out the earth line.Disconected the
Disconected the cable,crew out the earth line.Disconected the
water pipe on the back at the same time,pull out the pipe from
water pipe on the back at the same time,pull out the pipe from
water pipe on the back at the same time,pull out the pipe from
the cabinet,then take the door off.(only PBFS21* and PRFS25*)
the cabinet,then take the door off.(only PBFS21* and PRFS25*)
the cabinet,then take the door off.(only PBFS21* and PRFS25*)
Water Line
Cover
Screw A
Black Locking
Clips
Water
Line A
Publicité
