Power Dynamics CSBT Serie Manuel D'instructions page 3

INSTALLATION
1. Drill a hole in the ceiling, big enough to fit the speaker.
2. Connect the active and passive speaker by speaker cable (+ / -) (picture below).
3. Optional: connect the speakers with an amplifier via the line input for wired setup.
4. Connect the active speaker with the 12VDC plug (picture below).
5. Insert the speaker in the hole.
6. Screw down each of the two screws (the locking tabs will swivel into the rear surface).
7. Place the metal grill.
CONNECTING WITH BT
To connect your BT-device to the speakers, follow below steps:
1. Turn on BT on your device
2. Search for "BT-SPEAKER"
3. Connect with "BT-SPEAKER"
Your device is now connected, no password needed.
DISCONNECTING OR RECONNECTING
If you want to change from BT-device, follow below steps:
1. Disconnect the current BT-device ("OFF")
2. Connect new BT-device by following above steps
If you move out of range or turn off the BT function on your BT-device, the speaker will disconnect. To reconnect
turn on the BT on the BT-device, it will reconnect automatically.
3