Wilfa CHILL 12 CONNECTED Manuel D'instructions page 18

TIMER SETTING (1HOUR-24HOURS)
EN
The timer has two ways of operation:
To turn off
(When power
on)
To turn on
(When power
off)
Cancel timer
OVERLOAD PROTECTION
In the event of a power loss, to protect the compressor there is a 3-minute delay
until the compressor restarting.
DRAINAGE
MANUAL DRAINAGE
1. When the machine stops after the water is full, please unplug the power plug.
Notes: Please move the machine carefully, so as not to spill the water in the water
pan at the bottom of the body.
2. Place the water container below the side water outlet behind the body.
3. Unplug the water plug, the water will automatically flow into the water container.
Notes:
1. Keep the water plug properly.
2. During drainage, the body can be tilted slightly backwards.
3. If the water container cannot hold all the water, before the water container is full,
stuff the water outlet with the water plug as soon as possible to prevent water from
flowing to the floor or the carpet.
4. When the water is discharged, stuff the water plug.
Notes: Restart the machine after the water plug and drainage cover are installed,
otherwise condensate water of the machine will flow to the floor or the carpet.
SELF- EVAPORATING SYSTEM
The self-evaporating system uses the collected water to cool the condenser coils
for better, more efficient performance. There is no need to empty the drainage
tank in cooling mode, except in high humidity conditions. In drying mode, the
drainage tank needs to be emptied. The condensed water evaporates at the
INSTRUCTION MANUAL · AIR CONDITION
Press the Timer key
è
to turn on the timer
function.
Press the Timer key
è
to turn on the timer
function.
Press Up /Down repeatedly until the LED shows '00'.
Note: by pressing POWER you will also cancel the
è
timer
16
Press Up /Down
è
repeatedly to set the
delay OFF time.
Press Up /Down
è
repeatedly to set the
delay ON time.