Tristar SM-6000 Mode D'emploi page 15

Twin needle (figure 1)
• Take out the single needle, then put the twin needle. Put two bobbins
onto the winding thread guide, same as picture. Two stitches separately
insert into two pinpole of twin needle.
• Other steps are same as threading the single needle.
• Note: Twin needle is only suitable for straight stitch. It can sew two
straight stitches in parallel.
Upper thread (figure 1+2)
For quick and easy installation of the upper thread follow the steps below.
The open line in the picture below, suggests the thread which goes
through the device. The enlargements can be a clarification of the step.
• Put the bobbin on the bobbin winder and guide the thread over the
winding thread guide from right to left. Push thread tension release
bar (A) to left, then guide the thread down between the tension disc
making sure that the thread has been inserted into the tension disc.
• Continue to draw the thread down and around the thread pulling bar
fixed holder spring (B) from left to right.
• Draw the thread up, through the take-up lever draw (C) from left to
right.
• Continue to draw the thread down through the upper guide (D) from
front to back.
• Drawing down the thread and through the lower guide from back to
front.
• Continue to draw down the thread through the thread protector (E).
• Finally thread the needle from front to back (important !)
(figure 1)
(figure 2)
C
A
B
D
E
Sewing machine
1 2
EN
15