MV Agusta F3 675 RC Mode D'emploi page 154

4.4.9. How to select the mapping of the control unit
On F3 models it is possible to select different control
unit mappings which allow to obtain variable power and
performance characteristics based on the type of vehi-
cle use.
NOTE
The mapping selection may be performed
even during the use of the vehicle.
The mapping of the control unit can be selected by
pressing the start button when the engine is switched
on; this way the mapping switches to the following set-
ting value. The corresponding mapping characteristics
are listed in the following table.
Mapping
N
Mode
Normal
OPERATION
R S C
Rain Sport
ustomised
- 61 -
4
4