MV Agusta F3 675 RC Mode D'emploi page 113

Engine stop switch
It is used to switch off the engine. The ignition circuit is disabled, preventing the engine from being
restarted. To be able to restart the engine, return the switch to its original position.
NOTE
Under normal conditions, use this switch to shut off the engine.
3
Engine start button
It is used to start the engine and, when the engine is running, to select the different functions of the dis-
play installed on the instrument panel.
CAUTION
To avoid damaging the electrical equipment, be sure not to hold down the button for longer
than 5 consecutive seconds. If, after some attempts, the engine does not start, refer to the
chapter "TROUBLESHOOTING" later in this manual.
Throttle twist grip
It controls the fuel-air mixture supplied to the engine, which regulates engine speed. To increase engine
speed, rotate the hand grip from its idle position counterclockwise.
WARNING
If your motorcycle has toppled over or has been involved in an accident, have the working of
the throttle control checked by a MV Agusta authorized center before restarting.
CONTROLS AND INSTRUMENTS
- 20 -
3