Nordcap DOLCE VITA 10-LX Mode D'emploi page 7

Before connecting the machine to the power supply plug, leave the machine in stop position for at least 1 hour. In case the machine
has been transported in horizontal position, leave it in stop position for at least 24 hours.
After connection, operate the equipment empty for at least two hours with lights switched off, then proceed and load the products,
paying attention not to put them beyond the shelf edges, as beyond the front part of the shelf, the temperature is not sufficient for
proper conservation, while on the rear part, the products obstruct the good circulation of the cooled air.
THE PRODUCT POSITION INSIDE THE EQUIPMENT SHALL NEVER EXCEED THE MAX LOADING LEVEL OF THE TANK
(RED LINES).
DO NOT STORE IN THE EQUIPMENT SMOKED PRODUCTS OR PRODUCTS CONTAINING VINEGAR OR HOT PEPPERS,
AS THEY CAN DAMAGE THE EVAPORATOR COPPER PARTS.
PUT THE PRODUCT IN THE EQUIPMENT ALREADY AT STORAGE TEMPERATURE;
FROZEN PRODUCTS SHALL BE PUT IN THE EQUIPMENT AT A STORAGE TEMPERATURE NOT HIGHER THAN -18°C,
EXCEPT FOR SHORT ADMITTED PERIODS AT -15°C;
ONLY FOR CONGELATORS
To frost fresh food stuff we advise to:
•
Switch on the quick frosting switcher at least 24 hours before introducing the food stuff to be frozen;
•
If the food stuff to be frozen is hot or warm wait until they reach the room temperature before freezing.
•
Put the staff to freeze where it can better touch the inner side of the freezer and avoid it touching the already
frozen stuff (MAX 4,5 kg/100 litres net refrigerated volume);
•
If necessary transfer the already frozen stuff inside the baskets (that are good just to keep frozen not to frost);
•
Wait 24 hours before switching off the quick frosting switcher, (unless some other stuff is putted in to be frost).
Use exclusively the accessories supplied with the box. Any other "self-service" added equipment can affect the regular air circulation
and cause improper operation of the equipment.
SUGGESTIONS FOR THE ENVIRONMENTAL PROTECTION
Packaging
The packaging material is 100% recyclable and is marked with the symbol of recycling. For disposal, follow the local regulations. The
packaging material (plastic bags, parts in polystyrene, etc.) must be kept out of reach of children, as it is potential source of hazard.
Product
This equipment is marked in compliance with the European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE).
Make sure that this product is properly disposed, in order to give your contribution to prevention of any possible negative consequences
for the atmosphere and the health. The symbol on the product or the documentation indicates that this product does not have to be
disposed like domestic waste, but it must be delivered to the suitable collection point for recycling of electronic and electric equipment.
For further information on disposal, recovery and recycling of this product, contact the suitable local office, the city waste collection
service or the distributor from which the product has been purchased or obtained.
Before every intervention, the user has to disconnect the power supply plug. The refrigerator mechanical parts do not need any periodic
maintenance, but for a long-lasting life of the equipment, periodic cleaning is fundamental:
• EXTERNAL BOX: just clean it up with a dry soft cloth, in case of resistant spots, use lukewarm water and neutral detergents, then
rinse well and dry.
• PARTS IN STEEL: wash with lukewarm water and neutral soaps, dry with a soft cloth, do not use steel wool, as it can damage the
surface.
• PARTS IN PLASTICS: wash with water and neutral soaps. Rinse well and dry with a soft cloth, do not use alcohol, acetone and
other solvents, as they can damage the surface permanently.
• PARTS IN GLASS: use only specific products, do not use water, as it can build limestone on the glass surface.
COMMISSIONING
ACCESSORIES
PERIODIC MAINTENANCE
7