Installation Instructions; Electrical Connection - Cavist 48 Manuel D'utilisation

INSTALLATION INSTRUCTIONS

Before Using Your Wine Cooler
Remove the exterior and interior packing.
Before connecting the wine cooler to the power source, let it stand upright for approximately
4 hours. This will reduce the possibility of a malfunction in the cooling system from improper
handling during transportation. Clean the interior surface with lukewarm water using a soft cloth.
(Cleaning instruction on page 9)
Installing Your Wine Cooler
This wine cooler is designed to be free standing only, and should not be recessed or built-in.
Allow 5 inches of space between the back and sides of the wine cooler, which allows the proper
air ventilation. Adjust the feet to keep the wine cooler level. Locate the wine cooler away from
direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the
acrylic coating and heat sources may increase electrical consumption. Ambient temperature below
5°C or above 32°C will hinder the performance of this appliance.
This unit is not designed for use in a garage or any other outside installation.
Avoid locating the wine cooler in moist areas.
Plug the wine cooler into dedicated, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
This unit is not designed to be installed in an RV or used with an inverter.
After plugging the wine cooler into a wall outlet, turn the unit on and allow the unit to cool down
for 3 ~ 4 hours under before placing wine bottles or beverages in the appliance.
WARNING: Keep ventilation openings in the appliance enclosure, clear of obstruction.

ELECTRICAL CONNECTION

~WARNING~
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord
is damaged, have it replaced by an authorized service center.
This wine cooler should be properly grounded for your safety. The power cord of this wine cooler
is equipped with a three-prong plug which mates with standard three prong wall outlets to
minimize the possibility of electrical shock.
Do not, under any circumstances, cut or remove the third ground prong from the power cord
supplied. This wine cooler requires a standard 220-240 Volt AC~50Hz electrical outlet with three-
prong ground.
This wine cooler is not designed to be used with an inverter.