Brewing coffee (2 cups)
! Before brewing coffee, make sure the water tank and
the coffee tank are full and that the display shows:
SELECT PRODUCT
READY FOR USE
To brew the coffee, press first the
coffee brewing key (
,
the display, e.g.:
2 SMALL COFFEES
DISPENSING
In this operating mode the machine automatically
grinds and measures out the right amount of coffee.
! The preparation of two coffees requires two grinding
cycles and two separate brew cycles. These are
handled automatically by the machine.
Next the brew cycle is started.
2 SMALL COFFEES
PREBREWING...
After the prebrewing cycle, the coffee begins to come
out of the brew unit spout.
The display will show:
2 SMALL COFFEES
DISPENSING
Dispensing stops automatically when the set level is
reached.
! It is possible to interrupt dispensing coffee by
pressing (
,
or
) key; If the first coffee is
interrupted, the second will not be dispensed.
Place 2 cups beneath
the brew unit spouts.
You can adjust the
height of the brew unit
to your cups by shifting
it up or down manually.
key, and then the
or
). This is shown on
Dispensing hot water
! At the start, short spurts of hot water may be
dispensed. Danger of scalding. The hot water spout
can reach high temperatures. Do not touch it with
bare hands.
Before dispensing water, make sure the following is
shown on the display:
SELECT PRODUCT
READY FOR USE
2.Press the
key; the display shows:
HOT WATER
! A preset amount of water is dispensed. This may be
modified in the "PROGR. WATER AMOUNT" menu
described in the chapter on "Programming".
To stop dispensing hot water, press the
The machine returns to normal operating mode.
Brewing steaming/cappuccino
Steam can be used to froth milk for cappuccino and
also to heat beverages.
! Danger of scalding! At the start, short spurts of hot
water may be dispensed. The brewing spout can reach
high temperatures: Do not touch it with bare hands.
When the machine is
ready to brew coffee,
proceed as follows:
1. Place a cup and/or a
container below the hot
water/steam spout.
key again.
NA
11