Publicité
Les langues disponibles
Les langues disponibles
SCREEN DISPLAY GUIDE
1.Car voltage indicator
2.Car voltage
3.Car voltage indicator
4.Ready to start
5.The capacitor is being charged
CONNECTION INSTRUCTIONS
• Check the polarity of the battery posts. The POSITIVE (POS, P, +) battery post usually has a larger diameter than the NEGATIVE
(NEG, N, -) post.
• Follow the manufacturer's instructions to remove any insulating cover on the battery terminals.
• Connect the red positive (+) clamp to the positive terminal of the car battery.
• Connect the black negative (-) clamp to the negative terminal of the car battery.
• Always keep connecting the connector cable and the signal cable on the car battery before you start the car.
>6V
NOTE
• Turn off ALL electronics in your vehicle (air conditioner, heat, radio, lights, chargers, etc.) to ensure the best performance of your jump
starter.
• Ensure key is in the "OFF" position in the ignition. For push-to-start vehicles make sure the vehicle is completely "OFF" before jump
starting.
THREE SIMPLE STEPS TO GET YOUR CAR STARTED
THREE SIMPLE STEPS TO GET YOUR CAR STARTED
1
1. Connect your jump starter according to the recommendations in the above Connection Instructions.
1. Connect your jump starter according to the recommendations in the
2. Press ON/OFF, jump starter will start to recharge itself. The LCD shows PREPARING to indicate the charging status of the capacitor.
above Connection Instructions.
3. After the jump starter is fully charged the LCD shows READY, turn on engine.
2. Press ON/OFF, jump starter will start to recharge itself. The LCD shows
PREPARING to indicate the charging status of the capacitor.
3. After the jump starter is fully charged the LCD shows READY, turn on
OVERRIDE FUNCTION
engine.
If the start has failed by standard operation above, the vehicle's system may not allow the start as the battery voltage is low or the system
protection of vehicle has been activated. In that case, please use the override function to start your vehicle.
TROUBLE SHOOTING
Code
Car voltage is too high.
F01
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland S.A., ul. Przejazdowa 21, 05-800 Pruszków, www.hoegert.com
2
Cause
Check the battery and make sure the
voltage is no higher than 13.8V.
Check the battery and make sure the
3
READY
Solution
5
Publicité
