Publicité
Les langues disponibles
Les langues disponibles
Setting the Clock
This may be operated only with the remote control.
In this example, the clock is set for the 12-hour (AM 12:00) display.
1
Press the CLOCK button and within 3 seconds, press
the MEMORY button.
2
Within 1 minute, press the PRESET (
select 12-hour or 24-hour display and then press the
MEMORY button.
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"0:00"
The 24-hour display will appear.
(0:00 - 23:59)
Note that this can only be set when the unit is first installed or it
has been reset. (Refer to step 3 under "If trouble occurs" on
page 26.)
3
Within 1 minute, press the PRESET (
adjust the hour and then press the MEMORY button.
z When the 12-hour display is selected, "AM" will change au-
tomatically to "PM".
4
Within 1 minute, press the PRESET (
adjust the minutes and then press the MEMORY button.
z The hour will not advance even if minutes advance from "59"
to "00".
z The clock starts from "0" second. (Seconds are not dis-
played.)
To confirm the time display when the power is on:
or
) button to
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The time will flash at the push of the CLOCK button when the AC
power supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the Clock" from the beginning.
To change the 12-hour or 24-hour display:
1 Clear all the programmed contents. [Perform to step 3 under "If
trouble occurs" on page 26 for details.]
2 Perform "Setting the Clock" from the beginning.
or
) button to
or
) button to
E-13
ENGLISH
Publicité
