Evolution MINIBELT2 Traduction D'original page 14

MAINTENANCE
Note: Any maintenance must be carried out with the machine
switched off and disconnected from the power supply.
Check that all safety features and guards are operating
correctly on a regular basis. Only use this machine if all
guards/safety features are fully operational.
All motor bearings in this machine are lubricated for life.
No further lubrication is required.
Use a clean, slightly damp cloth to clean the plastic parts of
the machine. Do not use solvents or similar products which
could damage the plastic parts.
WARNING: Do not attempt to clean by inserting pointed
objects through openings in the machines casings etc.
The machines air vents should be cleaned using
compressed dry air.
Excessive sparking may indicate the presence of dirt in the
motor or worn out carbon brushes. If this is suspected have the
machine serviced and the brushes replaced at an authorised
service centre.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed
of with household waste. Please recycle where
facilities exist. Check with your Local Authority
or retailer for recycling advice.
14
www.evolutionpowertools.com