Evolution MINIBELT2 Traduction D'original page 10

Fig. 1
Fig. 2
Fig. 2
OPERATION
Note: This machine is supplied with two (2) Sanding Heads –
a single wheeled head and a twin wheeled head. (Fig. 1)
This gives the operator the opportunity to select the head
best suited to the task in hand. Either head accepts the
standard sanding belts supplied.
1. Changing the Sanding Head
WARNING: The machine must be disconnected from its power
source before changing the Sanding Head is attempted.
• Remove the sanding belt as detailed in 2 below.
• Slowly and carefully unscrew the Belt Centring Control
Screw with one hand, whilst holding the sanding head
with the other hand. (Fig. 2)
Note: The Sanding Head is sprung loaded, and the operator
should carefully observe the position and deployment of the
spring as the Sanding Head is released from the Sanding Arm.
Allow the compression in the spring to gradually ease and
carefully remove the spring from its locating socket in the
Sanding Arm and store safely for future use.
• The Sanding Heads can only be successfully fitted one way
round, and we recommend that the operator has a 'dry run'
without the spring being fitted to familiarise themselves
with procedure.
• Fit the spring into its locating socket towards the front of
the Sanding Arm. (Fig. 3)
• Align the Sanding Head with the Sanding Arm, ensuring that
the free end of the spring is located on the 'lug' cast into the
'inner' face of the Sanding Head.
• Replace the Belt Centring Screw and slowly turn the screw
clockwise so that it draws the Sanding Head into the
Sanding Arm.
• Centre the sanding belt as detailed in 3 below.
10
www.evolutionpowertools.com