Volpi Kamikaze KV380 Mode D'emploi page 36

•
Do not move the tool during the pruning shear cutting, it can cause danger.
•
Do not use the device in rain or humidity environment.
•
If the pruners stop working during long term use and you hear 4 fast beeps, this is an indication of
undervoltage protection which means the battery is depleted. Please charge as soon as possible.
•
Switch off the device after use and remove the battery from the pruner.
•
If no operation for 10 minutes, the pruner switches off automatically.
Caution: please check battery charge level or blade sharpening when cutting is difficult
or not smooth.
14.1. Cutting control mode
The KV380 electric pruning shears has two cutting control modes:
Non-progressive cutting control
Progressive cutting control
NON-PROGRESSIVE CUTTING CONTROL
When the pruning shear is turned on, the progressive cutting control is predetermined, that is, when the
trigger is actuated the blade moves according to the depth of the trigger drive, that is, if the trigger is
activated halfway, the blade moves progressively halfway through its opening
PROGRESSIVE CUTTING CONTROL
To change the control mode, you must hold the trigger for 2 seconds until you hear an audible warning (a
beep), which indicates that you have changed from progressive cut control mode to normal cut control
mode.
In the progressive cutting control, the blade moves according to the depth of the trigger drive, that is, if
the trigger is activated halfway, the blade moves progressively halfway through its opening.
36