BorMann Pro BWR5118 Mode D'emploi page 6

EN
Operating instructions
WARNING! ENSURE THAT YOU READ, UNDERSTAND AND APPLY THE SAFETY INSTRUCTIONS AND WARNINGS BEFORE USE.
• Place the heel block on press bed frame, then insert workpiece onto the heel block.
• Close the release valve by turning it clockwise until it is firmly closed.
• Pump the handle until serrated saddle nears workpiece.
• Align workpiece and ram to ensure center-loading.
• Pump the handle to apply load onto workpiece.
• When work is done, stop pumping the handle, slowly and carefully remove load from workpiece by turning the release valve counterclockwise in small
increments.
• Once ram has fully retracted, remove workplace from bed frame.
Maintenance
•Clean the outside of the press with dry, clean and soft cloth and periodically lubricate the joints and all moving parts with a light oil as needed.
•When not in use, store the press in a dry location with ram and piston fully retracted.
•When press efficiency drops, purge always air from hydraulic system as described before.
•Check the hydraulic oil; remove the oil filler nut on the top of the reservoir, if the oil is not adequate, fill with high quality hydraulic jack oil as necessary,
then replace the oil filler nut, purge away air from the hydraulic system.
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of
the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may
not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection or replacement work, including maintenance and special adjustments, must only be carried out by
technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury or death. The manufacturer and the
importer shall not be liable for injuries and damages resulting from the use of non-conforming equipment.
6
WWW.NIKOLAOUTOOLS.GR