Publicité
Les langues disponibles
Les langues disponibles
HWP & HWT SERIES
5.4 SPARK PLUG SERVICE
Note
Do not rinse spark plug in water. Follow guidelines and be careful not to
overtighten the spark plug
Tighten ½ turn when installing a new spark plug.
Tighten ¼ turn when re-installing an old spark plug.
1.
Disconnect and remove the spark plug using a wrench.
2.
Inspect the spark plug and clean any dirt from the electrodes with a wire
brush. If electrodes are worn or show signs of wear, replace spark plug.
3.
Measure the electrode gap with a spark plug gauge and adjust as necessary
by bending the side electrodes. Ensure that the gap is between 0.7 and
0.8mm.
4.
Reinsert the plug carefully. Tighten with a spark plug wrench.
Spark Plug
Electrode Gap
0.028 - 0.031 in
(0.7 - 0.8 mm)
35
Publicité
