Kicker DXA.2 Serie Manuel D'utilisation page 3

The DXA amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level
signals from your car stereo's source unit. A high-level signal can be run from the source unit's speaker outputs
to the stereo RCA input on the end panel of the amplifi er using the KICKER KISL as shown (make sure you set
the DXA amplifi er's input level switch to "HI"). Alternatively, the signal can be delivered to the amplifi er using the
low-level RCA outputs on the source unit. Set the input level switch on the end panel of the amplifi er to "LO".
Keep the audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this
wiring, cross it at a 90 degree angle.
core conductor
source unit
high-level speaker
outputs
+
–
Install a fuse within 18" (45cm) of the battery and in-line with the power cable connected to your amplifi er. If you
ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the amplifi er--just the opposite as when you installed it.
Model External Fuse
(sold separately)
DXA125.2 1 x 40 Ampere
≤24"
(60cm)
bare-metal
chassis ground
2014 DXA Stereo Amp Rev B.indd 3 2014 DXA Stereo Amp Rev B.indd 3
to amplifi er
shield
Power/Ground Wire
8 Gauge
external fuse
remote turn-on
(see page 5)
KICKER KISL (optional)
OR
KICKER Wiring Kit
PK8, ZCK84
≤18"
(45cm)
12V
battery
to amplifi er
from source unit high-
level speaker outputs
bare-metal
chassis ground
3
8/2/2013 3:32:27 PM 8/2/2013 3:32:27 PM