Publicité
Les langues disponibles
Les langues disponibles
Authorized KICKER Dealer:
Purchase Date:
Serial Number:
PERFORMANCE
Model:
RMS Power
@ 14.4V, 4Ω stereo, ≤ 1% THD+N
@ 14.4V, 2Ω stereo, ≤ 1% THD+N
@ 14.4V, 4Ω mono, ≤ 1% THD+N
Length [in, cm]
Height [in, cm]
Width [in, cm]
Frequency Response [Hz]
Signal-to-noise Ratio [dB}
Input Sensitivity
Electronic Crossover
KickEQ™ Bass Boost
Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4" (10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill
four holes using a 7/64" (3mm) bit and use the supplied #8 screws to mount the amplifi er.
Wiring: Disconnect the vehicle's battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er. Make the ground wire short, 24" (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicle's chassis. Adding an additional ground wire of this same gauge (or larger) between the
battery's negative post and the vehicle chassis is recommended.
2
2014 DXA Stereo Amp Rev B.indd 2
2014 DXA Stereo Amp Rev B.indd 2
DXA.2-SERIES AMPLIFIER
OWNER'S MANUAL
MODEL:
DXA125.2
DXA125.2
30 x 2
60 x 2
125 x 1
8-1/8, 21
2-3/8, 6
7-3/16, 18
10Hz–20kHz
>95, A-weighted, re: rated power
Low Level: 125mV–5V
High Level: 250mV–10V
HI, LO or OFF; Variable 50–200Hz @ 12dB/Octave
Variable 0-12dB @ 40Hz
8/2/2013 3:32:27 PM
8/2/2013 3:32:27 PM
Publicité
