GE JGP932 Instructions D'installation page 14

MAKING THE LP CONVERSION
CHANGE THE COOKTOP
3
BURNER ORIFICES
Remove the top grates, burner caps,
A
burner heads and burner bases.
B Remove the
electrodes from the
burner base. Using a
No. 15 "Torx" head
driver bit, remove the
screws holding the
burner base in
position.
Using a 7mm or
C
9/32" nut driver,
remove the top
burner orifices.
These may be
accessed through the
hole in the cooktop.
NOTE: The orifices have
a spring loaded retaining
ring around the hex head
to hold the orifice in
the nut driver during
installation and removal.
A slight amount of force is required to push
the nut driver down over the ring.
D Locate the LP/Propane orifices shipped
inside the literature package. They
will have a digit number and the letter
"L" on the side. (Important: Save the
orifices removed from the appliance
for future use.)
Each orifice will show a series of
engraved marks, (I, II, III or X), located
on the top.
I II
These marks denote the precise location of
each orifice to the cooktop burner.
Installation Instructions
Remove
This
Assembly
Orifice Spud Located
Thru This Opening
Retainer
Ring
III X
14
(CONT.)
Units with 1500 BTU/HR burner on right front.
(See rating plate on bottom of appliance.)
III
II
Units with 9100 BTU/HR burner on right front.
(See rating plate on bottom of appliance.)
II
II
E Install the LP/Propane orifices in
their precise locations as noted in the
illustrations above.
F Return the natural orifices to the
bracket and reattach the bracket and
the instruction sheet to the pressure
regulator using the screw previously
removed.
Replace the burner bases, heads,
G
caps and top grates. (NOTE: When
re-attaching the burner bases to glass
top units, tighten screws to a maximum
of 10 in.-lbs torque.)
I
X
I
II