Hilti AIC 1000-E Mode D'emploi page 7

▶ Do not lay the supply cord under carpeting, furniture or other appliances. Do not cover the cord
with throw rugs, runners or similar coverings. Arrange the supply cord away from traffic areas and
ensure that the supply cord does not cause tripping hazards.
▶ Insert the plug in a suitable earthed/grounded power outlet which has been correctly and safely
installed and is in compliance with local regulations. If you are in doubt about the effectiveness of
the power outlet's earth/ground connection, have it checked by a qualified specialist.
▶ Do not expose the product to rain or moisture. Water entering an electric device will increase the risk
of electric shock.
▶ Check to ensure that the supply cord does not lie in a puddle of water.
▶ Check the product's supply cord at regular intervals and have it replaced by Hilti Service if damage
is found. Check extension cords at regular intervals and replace them if found to be damaged.
▶ Do not touch the supply cord or extension cord if they are damaged while working. Disconnect
the supply cord plug from the power outlet. Damaged supply cords or extension cords present a risk
of electric shock.
▶ The electric supply cord may be replaced only with a cord of the type specified in the operating
instructions.
▶ Do not abuse the cord. Never use the cord for carrying, hanging up or unplugging the product.
Keep the cord away from heat, oil, sharp edges and moving parts of the product. Damaged or
entangled cords increase the risk of electric shock.
▶ In the event of an interruption in the electric supply, switch the product off and unplug it from the
power outlet.
▶ Use the power outlet on the product only for the purposes described in the operating instructions.
▶ Never operate the product when it is dirty or wet. Dust (especially dust from conductive materials) or
dampness on the surface of the product may, under unfavorable conditions, lead to electric shock. Have
dirtied or dusty products checked at regular intervals by Hilti Service, especially if they are used
frequently for working on conductive materials.
2.5 Personal safety
▶ Do not use the product where there is asbestos contamination.
▶ Stay alert, watch what you are doing and use common sense when working with the product. Do
not use the product while you are tired or under the influence of drugs, alcohol or medication. A
moment of inattention while operating the product can result in serious personal injury.
▶ Avoid unusual body positions. Keep proper footing and balance at all times.
▶ During use and maintenance of the product, the user and persons in the vicinity must wear suitable
eye protection, a hard hat, ear protection, protective gloves, protective footwear and respiratory
protection appropriate for the dust load.
▶ Make sure that the product cannot roll away or fall.
▶ Observe the accident prevention regulations applicable in your country.
▶ If devices are provided for the connection of dust extraction and collection facilities, ensure these
are connected and properly used. Use of a vacuum cleaner can reduce dust-related hazards.
▶ This product is not intended for use by persons (including children) with physical, sensory or mental
disabilities or persons lacking the appropriate experience and/or knowledge. These persons must receive
instruction in safe handling of the product and must be supervised throughout their use of the product
by a responsible person.
▶ Children must receive instruction and be supervised to ensure that they do not play with the product.
▶ This product can be used by children 8 years of age or older and by persons with physical, sensory
or mental disabilities or little relevant experience or know-how if they are supervised or have received
instruction on the safe use of the product and the resulting hazards. Do not allow children to play with the
product. Do not allow unsupervised children to clean the device or to carry out user-maintenance tasks.
2.6 Additional safety instructions
▶ Do not use the product if the supply cord and/or the plug is damaged. Make sure that supply cord and
extension cord are not exposed to moisture and/or damp. Do not touch the supply cord if it is damaged
while work is in progress.
▶ Before starting, check all filters and seals and replace damaged filters. Operate the product only with
approved filters (pre-filters and main filters) installed.
▶ Do not allow water to collect in the hollow of the grip. Clean the drain hole at regular intervals.
▶ Whenever the room is occupied, always operate the product at the highest power level.
▶ Make sure that the main-filter frame is securely installed and correctly seated.
*2297302*
2297302 English 3