Publicité
Les langues disponibles
Les langues disponibles
90550130 PC1800HD hammer drill
• When using an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. The following table shows the correct size
to use depending on cord length and nameplate ampere rating. If in doubt, use the
next heavier gage. The smaller the gage number, the heavier the cord.
Recommended Minimum Wire Size for Extension Cords
Total Length of Cord
25 ft.
50 ft.
7.6 m
15.2 m
Wire Size AWG
18
18
FUNCTIONAL DESCRIPTION
Figure A
1. Trigger Switch
2. Forward/Reverse Button
3. Torque Adjust Collar
4. Dual Range Gearing
5. Keyless Chuck
6. Bit Holder
7. Battery
8. Battery Release Button
This product can accept any of the batteries and chargers listed in the chart below.
LI-ION Battery Packs and Chargers
Description
Battery:
LI-ION 18V
Charger: LI-ION
IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY
CHARGERS
SAVE THESE INSTRUCTIONS: This manual contains important safety instructions for
battery chargers.
• Before using charger, read all instructions and cautionary markings on charger, battery
pack, and product using battery pack.
:
Shock hazard. Do not allow any liquid to get inside charger.
:
Burn hazard. To reduce the risk of injury, charge only designated
PORTER-CABLE batteries. Other types of batteries may burst causing personal injury
and damage.
4/3/09
2:40 PM
Page 5
75 ft.
100 ft.
125 ft.
22.9 m
30.5 m
38.1 m
16
16
14
A
3
5
NI-CD Battery Packs and Chargers
Cat. #
Description
PC18BL
Battery: NI-CD 18V
PC18BLX
Charger: NI-CD
PC18BLEX
PCLMVC
PCXMVC
5
150 ft.
175 ft.
45.7 m
53.3 m
14
12
4
2
1
6
8
7
Cat. #
PC18B
PCMVC
PCXMVC
Publicité
