Publicité
Les langues disponibles
Les langues disponibles
-
If the water level drops in the case, re-examine the suction pipe fitting and proceed to again fill the
casing.
-
Turn off the discharge line valve of your installation.
-
Ensure that there is no water on the electrical parts of the pump and that there is no leakage.
-
Connect the power plug to a 10/16A socket featuring an earthing pin.
-
Activate the power supply switch.
-
The pump starts working and cuts out automatically as soon as pressure in the tank reaches 3 bars
approx.
-
Slowly open the discharge line valve. The pump begins to discharge without the engine starting thanks
to the water stored in the tank.
-
When the pressure in the tank falls below 1.5 bars approx., the pump starts up and continues working as
long as the pressure in the tank does not reach 3 bars approx.
-
To stop the pump cycles, slowly close the discharge line valve.
-
Always follow these instructions in order to prevent overpressure in the circuit,
pressure fluctuations ("hammering").
IMPORTANT!
● Do not operate the pump without there being water in the pump casing:
prolonged operation of the pump while the discharge line valve is closed may seriously damage the
pump.
● Where there is a power failure, it is preferable to disconnect the power
plug or turn off the switch controlling the pump.
● When the pump is not to be used for an extended period, be sure to
also turn off the pump's power supply.
7) MAINTENANCE
- In winter, the pump must be carefully emptied or positioned where it cannot be affected by frost.
-
Before each new start-up, check that the gaskets are in good condition and that the fitting are airtight.
-
For all repair or maintenance work requiring dismantling of electrical parts, you must contact an
approved after-sales service agent (see the dealer).
PROTECTING THE ENVIRONMENT
Do not dispose of with regular household waste.
When the appliance is out of order or cannot be repaired, the packaging, accessories and
each part of the appliance must be dismantled, separated and taken to a recycling depot in
accordance with applicable local regulation.
GB
4
thereby avoiding
Publicité
