Ribiland PRSI24JET101I Manuel D'instructions Et D'utilisation page 3

WARNING! In order to reduce the risks of fire, electric shock and personal injury during the course of
installation and use of your pump, it is recommended that you always adhere to basic safety precautions,
including the following:
Read these instructions in their entirety before operating this machine and retain these instructions,
1) GENERAL REMARKS
The water pump is designed to suck up treated water.
The pump must be installed in a dry, ventilated location, not exposed to bad weather and heat; the maximum
suction height must not exceed 8 meters.
When correctly installed, your pump will operate with maximum efficiency and entirely to your satisfaction:
be sure to read the following instructions carefully.
2) TECHNICAL DATA
Water pumps may come equipped with tanks of stainless steel or steel with 19, 24, 36 or 50 liter capacity.
The reference assigned depends on the type of tank supplied:
Capacity 19 L
Material
STEEL S.STEEL
used
JET 81 517616 517616I
JET101 517716 517716I
JET121 517816 517816I
The specifications set out below are the same irrespective of the tank supplied:
Model
Type Self-priming
Max suction
Output 28 l/min at 8m
Discharge 24l/min at 15m
Motor power
Power supply 230 V/ 50Hz
Speed
(rounds / minute)
3) USE AND INSTALLATION
a) Use:
The water pump is designed for everyday use such as gardening, sprinkler systems, increasing water
pressure of the non-feed water distribution network, pumping of tank water and jet washing. The
pump/booster assembly maximizes water storage by limiting frequency of operation, and in particular
ensures constant pressure is maintained in the installation.
The pump must not be operated for uses not specified in this manual.
In particular, the pump must not be use for:
- Pumping of seawater, waste water, water containing solid bodies, sand or abrasive particles in
suspension, or water containing corrosive substances in general.
- Pumping of water whose temperature exceeds 35
- Pumping of explosive, inflammable or dangerous liquids.
b) Major recommendations:
Before connecting up to the electricity network, you must:
- Fasten the pump securely to the ground or a suitable support.
With that in mind, the four feet of the tank have been perforated so as to allow fastening bolts (not
supplied) to go through.
Directions for maintenance & use
SURPRESSOR PUMP JET 81-101-121
24 L
STEEL S.STEEL STEEL
517636 517636I 517656
517736 517266 517756
517836 517836I 517856
JET 81 JET 101
Self-priming
8 m 8 m
33 l/min at 8m
28 l/min at 15m
750 W 970 W
230 V/ 50Hz
2850 2850
GB
36 L 50 L
S.STEEL STEEL S.STEEL
517656I 517676 517676I
517756I 517776 517776I
517856I 517871 517871I
JET 121
Self-priming
8 m
35 l/min at 8m
31 l/min at 15m
1180 W
230 V/ 50Hz
2850
2