Elkay FLEXI-GUARD EZOOTL8WS 1A Serie Manuel D'installation Et Utilisation page 14

INSTRUCTIONS TO MOVE THE BOTTLE FILLER & BASIN
TO THE LEFT SIDE (NON-REFRIGERATED) FOR ALTERNATE MOUNTING
Using a 5/16" socket, remove
the (4) screws from the bottom
of each cooler to remove the
wrappers.
Refrigerated Cooler side:
Carefully lift and tip the shroud/basin
assembly off of the cooler frame.
Disconnect sensor black wire and red
wire from solenoid; disconnect sensor
white wire from white jumper wire.
Disconnect the water line at the solenoid
valve. Reference (Fig. 25, Pg.19) for the
operation of the quick connect fittings.
Non-Refrigerated Cooler side:
Carefully lift and tip the shroud/basin
assembly off of the cooler frame.
Disconnect sensor black wire and red
wire from solenoid; disconnect sensor
white wire from white jumper wire.
Disconnect the water line at the solenoid
valve. Reference (Fig. 25, Pg.19) for the
operation of the quick connect fittings.
1000005927 (Rev. E - 08/23)
EZOOTL8WS*1A LZOOTL8WS*1A
VERSATILE BI-LEVEL
Using a #T20 (6 point star bit),
loosen the shroud screws.
Both sides, both coolers.
Fig. 13
Page 14
Fig. 12
ONLY move the filler panel and j-clip
to the refrigerated (right) side
if right side will be mounted 'high'.
Fig. 14
Fig. 15