10. Care and cleaning
Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could damage the
casing or stop the product from functioning properly.
• The soldering station is maintenance-free, except for the occasional replacement of the soldering tip.
• Maintenance or repairs may only be carried out by a technician or a specialist repair centre. Under no circumstances
should you service any of the components in the interior of the product, therefore never open/dismantle it.
• Do not clean the product by immersing it in water.
• Use a slightly damp, lint-free cloth to clean the exterior of the product. Dust can be easily removed using a soft,
clean long-haired brush and a vacuum cleaner. Only use a small amount of water when cleaning the product.
• Before cleaning the soldering station, switch it off and unplug the mains socket from the mains. Leave the soldering
iron and the soldering station to cool down completely.
• The soldering tip does not require any special cleaning. It is sufficient to clean it occasionally by removing flux
residues or excess solder with the sponge.
• The soldering tip must be coated with tin before the soldering station is switched off. This prevents corrosion on
the soldering tip.
11. Disposal
Electronic devices are recyclable waste and must not be placed in household waste. Always dispose of the
product according to the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
22