FUXTEC FX-RM5170agile Mode D'emploi Original page 37

ORIGINAL USER MANUAL FUXTEC FX-RM5170agile rev01
Assembly upper and lower tie bar
Carefully unfold the lawnmower handle, not pinching or damaging the lawnmower control cables.
Open the handle and tighten the handle parts with the four wing nuts, one washer each and the
screws, as shown below. Insert the starter cable on the right side of the handle and secure it with the
plastic handle (see the following pictures).
If you want to adjust the handlebar height, you can choose the two holes "L" or "H" in the left and
right bracket to fix the handlebar with screws and buttons.
The "H" hole is the high position of the handlebar, and the "L" hole is the low position of the
handlebar.
37