Ayce HW-26MC05 Mode D'emploi page 26

NO. Picture Remark
Loose the 4 screws and fit the rear grille,
8
then re-tight them by the 4 screws.
Fit the fan blade into the motor axis,
9
and tight with the screws.
Loose the 4 screws on the mist motor assembly and fit
10
it into the front grille , then re-tight it by the screws.
Fit the rear grille into the front grille, and tight them with
the lock button on side .Then fit the screw bolt and tight
11
the both grilles with the nut.
Put the water tank onto the metal base with the lid open.
12
Put the electrical water pump into the water tank with
13
the 4 sucking pads at the bottom.
Loose the 2 screws on the control box assembly and
2)
open the cover. Connect the 3 electrical terminals
1)
as below,
3)
1) Left: 2-pins connector to pump,
2) Middle: 3-pins connector to fan motor,
3) Right: 4-pins connector to mist system.
14
Then fit the cable protect into the 3 holes on the control
box, and re-fit the cover and tight by the 2 screws. Before
fit the cover, make a note for the both water hoses,
hose A is hose through Mist adjustable button, hose B is
non-through the Mist adjustable button.
Hose A Hose B
NO. Picture Remark
While push the connect on the electrical pump, fit the
15
hose A about 5mm into the electrical pump connect,
then release the connect.
Connect C Connect D
Use similar method, connect the hose from mist motor
assembly to the connect D; Fit the separate connect hose
16
to connect C and the connect D on the mist motor
assembly.
Put the Hose B into the water tank.
17 Fill enough water into the water tank.
Lock the 2 wheels with locking fixation.
OPERATION
Please make sure all buttons are at OFF or CLOSE position, then connect the power supply.
Always keep the water tank open, do not close the tank, because it may jam the water hose.
1. Switch on the fan switch on the control box, then rotate the fan speed on the motor from" OFF"
to "1" or "2" or "3" to select the fan speed.
2. Rotate the Mist adjustable button to the middle position, then switch on the mist switch on the
control box, now the electrical pump will working, and mist function will occur. Now you can
adjust the mist performance by the Mist adjustable button.
3. When now use, please disconnect the power supply, and re-pack to your original package for
storage.
4. Oscillation function:
To get oscillation function, you must loose the bolt under the fan motor head, and change the
tighten position for the metal linkage to side hole. To cancel the oscillation function, you must
re-tighten the linkage back to the central hole position.
bolt
50 | 51 GB
hole