Haier LW-110G Instructions Pour L'emploi page 21

Electrical Safety Instruction
WARNING !
THIS APPLIANCE MUST BE EARTHED.
IF THE MAINS LEAD OF THE APPLIANCE
IS FITTED WITH A PLUG:
FUSE REPLACEMENT
If the mains lead of this appliance is fitted with a
BS 1363A 13 amp fused plug, to change a fuse in
this type of plug use a A.S.T.A. approved fuse to
BS 1362 type and proceed as follow:
1. Remove the fuse cover (A)
2. Remove the fuse (B)
3. Fit replacement fuse into plug
4. Refit the fuse cover
B
IMPORTANT:
The fuse cover mast be refitted when changing a
fuse and if the fuse cover is lost the plug must not
be used until a correct replacement is fitted.
Correct replacements are identified by the colour
insert or the colour embossed in words on the
base of the plug. Replacement fuse cover are
available from your local electrical store.
CONNECTION TO A REWIREABLE PLUG
If the fitted plug is not suitable for your socket
outlet, then it should be cut off and disposed of in
order to avoid a possible shock hazard should it
be inserted into a 13A socket elsewhere.
A suitable alternative plug should then be fitted to
the cable.
The wires in this mains lead are coloured in
accordance with the following code:
BLUE
BROWN
YELLOW & GREEN "EARTH"
A
1. The YELLOW & GREEN wire must be
2. The BLUE wire must be connected to the
3. The BROW wire mast be connected to the
"NEUTRAL"
"LIVE"
E
YELLOW & GREEN
N
BLUE
Connected to a
typical 13 amp plug
connected to the terminal in the plug which is
marked with the letter E
or by the Earth symbol
or coloured green or yellow & green
terminal which is marked with the letter N
or coloured black
terminal which is marked with the letter L
or coloured red
(N)
(L)
(E)
N
BROWN
CABLE CLAMP