Time-Setting Options; Kitchen Timer; Stopwatch; Automatic Safety Cut-Out - Bosch PKU375FB1E Mode D'emploi

Time-setting options

en
OTime-setting options
There are 2 different time-setting options:
i o n s T i m e - s e t t i n g o p t

Kitchen timer

■

Stopwatch

■
Kitchen timer
You can use the kitchen timer to set a time of up to
99 minutes. It runs independently of all the other
settings.
Setting the kitchen timer
If the appliance is switched off, touch the
1.
once; if it is switched on, touch the
The indicator lights up.
t
display.
When the appliance is switched on, pressing
Note:
the symbol once switches on the stopwatch.
0
Set the required time using the
2.
The timer starts counting down after a few seconds.
When the time has elapsed
When the time has elapsed, an audible signal sounds
and flashes in the display for 10 seconds.
‹‹
The indicator flashes.
t
Touch any symbol.
The indicators go out and the audible signal ceases.
Setting the correct time
Use the 0 symbol to select the kitchen timer and reset
the time.
Stopwatch
The stopwatch displays the time that has passed since
it was activated.
The stopwatch only works when the appliance is
switched on. When the appliance is switched off, the
stopwatch is switched off as well.
If the kitchen timer is selected in addition to the
Note:
stopwatch, the setting will appear on the timer display
for 10 seconds. The stopwatch will then be displayed
again.
Switching on
Touch the symbol.
0
1.
is shown on the display.
‹‹
Touch the buttons for temperature control.
2.
Timing starts. Seconds are displayed during the first
minute, then minutes.
Touch the symbol to show the timer display
0
3.
again.
24
0 symbol
symbol twice.
0
min lights up on the
‹‹
- buttons.
‹ Š
Switching off
Touch the symbol.
0
1.
Touch the temperature setting buttons.
2.
The stopwatch will be switched off. The timer display
will go out.
bAutomatic safety cut-out
If an appliance has been switched on for a long time
c u t - o u t A u t o m a t i c s a f e t y
without the setting being changed, the automatic switch-
off is activated.
The appliance stops heating.
indicator / flash alternately on the display.
• œ
The indicator goes out when you touch any of the
controls. You can implement new settings.
At what point the automatic switch-off is activated
depends on the grill setting selected (2 to 4 hours).
[Energy consumption
indicator
You can use this function to display the total energy
n i n d i c a t o r E n e r g y c o n s u m p t i o
consumption between switching the appliance on and
off.
Once switched off, the energy consumption in kilowatt
hours (e.g. 1.87 kWh) is displayed for 10 seconds.
The accuracy of the display depends, amongst other
things, on the voltage quality of the power supply.
The energy consumption display may not be
activated.~ "Basic settings" on page 25
and the residual heat
" ‰