Abus ESMO50001 Instructions D'installation Et D'utilisation page 31

Displays and functions
Displays and functions
Installation and programming
In order to complete programming on the alarm panel, please observe the installation
and user guide for the alarm panel. The options for programming of communication for
the alarm system can be found in the installation menu under "Communication".
Ensure that the alarm panel does not display setting options for the
mobile communication module if it is not inserted.
Note
If the alarm panel recognises the mobile communication module, then "mobile" is
displayed in the installation menu of the Secvest/Secoris under the item "Info"/ "about" →
"Communication".
In addition to this, you will be shown the mobile communication network name with the
current signal strength, the IMEI, the telephone number of the SIM card, the IMSI and
the version number of the module.
The SIM card telephone number is only displayed if your service provider has saved the
telephone number on the card.
If the signal strength is too weak, then the alarm panel should be installed
in a different location or the supplied antenna should be installed so that
there is optimum signal strength. Please find out about your service
Note
provider's network coverage in advance, and change providers if
necessary.
Testing for correct functioning using the alarm panel
Go to "Test", to the menu options NSL Reporting, Emergency Call, Voice Dialler, SMS or
Email, in the installation menu in order to test the functionality of the mobile
communication module. Select the appropriate communication method, such as
IP mobile or mobile.
You can find details in the instructions for installers for the alarm panel in question.
31