Philips FastCare GC7715/80 Mode D'emploi page 8

ENGLISH
8
Safety auto-off mode (specific types only)
- To save energy, the steam generator switches off automatically when it has not been used for
15 minutes. The 'iron ready' light flashes.
- To reactivate the steam generator, set the on/off switch to 'off ' position and then to 'on' position.
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance.
If you are unable to solve the problem with the information below, visit www.philips.com/support
for a list of frequently asked questions or contact the Consumer Care Centre in your country.
Problem
The iron does not
produce any
steam.
The Calc-Clean
light flashes and
the appliance
beeps.
The Calc-Clean
light flashes and/or
the appliance
beeps.
The Calc-Clean
light flashes and
the appliance
beeps every time I
press the steam
trigger. No steam
comes out of the
soleplate.
Possible cause
There is not enough water in
the water tank.
You have not pressed the steam
trigger.
You have set the temperature
dial to 1.
The steam function has been
disabled until you have
performed the Calc-Clean
process.
You have not placed the water
tank in the appliance properly.
This is the Calc-Clean reminder.
You have not done or have not
completed the Calc-Clean
process.
You have not done or have not
completed the Calc-Clean
process.
Solution
Fill the water tank beyond the MIN
indication. Press and hold the steam
trigger until steam comes out. It may take
up to 30 seconds until steam comes out.
Press and hold the steam trigger until
steam comes out.
Turn the temperature dial to 2 or
higher.
Perform the Calc-Clean process to
restore the steam function (see chapter
'IMPORTANT - Cleaning and
maintenance').
Slide the water tank into the appliance
until it locks into place ('click').
Perform the Calc-Clean process within
1 hour after the Calc-Clean reminder is
given.
Perform the Calc-Clean process to
enable the steam function again
(see chapter 'IMPORTANT - Cleaning
and maintenance').
Perform the Calc-Clean process to
enable the steam function again (see
chapter 'IMPORTANT - Cleaning and
maintenance').