Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Warning! If there is any anomaly, unplug your appliance. Only a qualified electrician or
competent person may carry out troubleshooting.
If there is any anomaly during operation, check the following points before calling our approved after
sales service or a qualified professional.
ERROR
MEANING
TYPE
E01
Sensor warning
E02
Sensor warning
E03
Sensor warning
E06
Sensor warning
E07
Sensor warning
E08
Low voltage
warning
E09
Freezer
compartment is
not cold enough
Some noises may be heard during normal appliance operation (compressor operating
cycle, automatic defrosting, circulation of the refrigerating gas through the appliance,
etc.).
If you cannot find the cause of the anomaly, only call our approved after sales service
or a qualified professional.
WHY
Power supply to the
device has dropped
to below 170V.
Likely to occur after
long term power
failure.
WHAT TO DO
Call Service for assistance as soon as
possible.
Call Service for assistance as soon as
possible.
Call Service for assistance as soon as
possible.
Call Service for assistance as soon as
possible.
Call Service for assistance as soon as
possible.
- This is not a device failure, this error helps
to prevent damages to the compressor.
- The voltage needs to be increased back to
required levels.
If this warning continues, an authorised
technician needs to be contacted.
1. Set the freezer temperature to a colder
value or set Super freeze mode. This should
remove the error code once the required
temperature has been reached. Keep doors
closed to improve time taken to reach the
correct temperature.
2. Remove any products which have
thawed/defrosted during this error. They
must be eaten within a short period of time.
3. Do not add any fresh food into the freezer
compartment until the correct temperature
has been reached and the error remains.
If this warning continues an authorised
technician needs to be contacted.
Publicité
