Télécharger Imprimer la page

Aiwa Z-L70 Mode D'emploi page 2

Publicité

Les langues disponibles

Les langues disponibles

AE!!!!!SA
"CAUTION:TO
REDUCE THE RISK OF
ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE
PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL."
Explanation of Graphical Symbols:
The lightning
flash with arrowhead
symbol,
A
within an equilateral triangle, is intended to alert
the user to the presence
of uninsulated
"dangerous
voltage"
within
the product's
enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons,
The exclamation
point within an equilateral
A
triangle
is intended to alert the user to the
presence
of
important
operating
and
maintenance
(servicing)
instructions
in the
literature
accompanying
the
appliance.
Owner's record
For your convenience,
record the model number and serial
number (you will find them on the rear of your unit) in the space
provided below. Please refer to them when you contact your
Aiwa dealer in case
of difficulty.
I Model No.
Serial No. (Lot No.)
CX-ZL70
SX-WZL70
I PX-E860
Read the Operating Instructions carefully and completely before
operating the unit. Be sure to keep the Operating Instructions
for future reference. All warnings and cautions in the Operating
Instructions
and
on
the
unit
should
be
strictly
followed,
as
well
as the safety suggestions below.
Installation
1 Water and moisture —
Do
not use this unit near water, such
as near a bathtub, washbowl, swimming pool, or the like.
2 Heat — Do not use this unit near sources of heat, including
heating vents, stoves, or other appliances that generate heat.
It also should not be placed in temperatures
less than 5°C
(41 "F) or greater than 35°C (95"F).
3 Mounting surface — Place the unit on a flat, even surface.
4
5
6
7
8
.* +
Ventilation — The unit should be situated with adequate
space around it so that proper heat ventilation is assured.
Allow 10 cm (4 in.) clearance from the rear and the top of the
unit, and 5 cm (2 in.) from each side.
- Do not place the unit on a bed, rug, or similar surface that
may block the ventilation openings.
- Do not install the unit in a bookcase, cabinet, or airtight rack
where ventilation may be impeded.
Objects and liquid entry — Take care that objects or liquid
do not get inside the unit through the ventilation openings.
Carts
and stands
— When
placed
or
mounted on a stand or cart, the unit should
be moved with care.
Quick stops, excessive force, and uneven
surfaces
may cause the unit or cart to
m
3
A&*
overturn or fall.
Condensation — Moisture may form on the CD pickup lens
when:
- The unit is moved from a cold spot to a warm spot
- The heating system has just been turned on
- The unit is used in a very humid room
- The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function
normally. Should this occur, leave the unit for a few hours,
then try to operate again.
Wall or ceiling mounting — The unit should not be mounted
on a wall or-ceiling,
u;less
specified
in the Operating
Instructions.
Electric Power
1
2
3
4
5
Power sources — Connect this unit only to power sources
specified in the Operating Instructions, and as marked on the
unit.
Polarization
— As a safety feature, some units are equipped
with polarized AC power plugs which can only be inserted
one way into a power outlet. If it is difficult or impossible to
insert the AC power plug into an outlet, turn the plug over and
try again. If it is not still inserted easily into the outlet, please
call a qualified service technician to service or replace the
outlet. To avoid defeating the safety feature of the polarized
plug, do not force it into a power outlet.
AC power cord
- When disconnecting the AC power cord, pull it out by the
AC power plug. Do not pull the cord itself.
- Never handle the AC power plug with wet hands, as this
could result in fire or shock.
- Power cords should be firmly secured to avoid being severely
bent, pinched, or walked upon. Pay particular attention to
the cord from the unit to the power socket.
- Avoid overloading
AC power plugs and extension cords
beyond their capacity, as this could result in fire or shock.
Extension cord — To help prevent electric shock, do not use
a polarized AC power plug with an extension cord, receptacle,
or other outlet unless the polarized plug can be completely
inserted to prevent exposure of the blades of the plug.
When not in use — Unplug the AC power cord from the power
outlet if the unit will not be used for several months or more.
When
the
cord is plugged in, a small amount of current
continues to flow to the unit, even when the power is turned
off.
2
ENGLISH

Publicité

loading