INTRODUCTION
Thank you for choosing a De'Longhi product. Please take a few
moments to read the instructions to avoid risks or damage to the
appliance.
Download the App!
DE'LONGHI
DEʼLONGHI
This appliance can be used also with the App Pinguino that can
be downloaded on the App Store®or on Google Play.
To gain access to all functions you need a local net (Home WLAN)
with access to Internet. Further check there are no obstacles to
the Internet access, such as Firewall, Proxy, authentications, etc.,
DESCRIPTION
Description of the appliance (See page 3 - A)
A1. Air outlet grid
A2. Control panel
A3. Handles
A4. Wheels
A5. Remote control signal receiver
A6. Remote control storage
A7. Filter
A8. Air intake grille
A9. Air exhaust hose housing
A10. Air intake grille
A11. Drainage hose with cap
A12. Power supply cable
Description of accessories (See page 3 - B)
B1. Wall flange with cap
B2. Air exhaust hose
B3. Window outlet
B4. Window bracket with pins
B5. Additional window bracket with pins
B6. Water drain hose with cap
B7. Remote control
B8. End of season dust cover
B9. End of season accessories bag
Electrical connection
Before plugging the appliance into the outlet, check that:
•
The outlet's power supply corresponds to the value
indicated on the rating label on the back of the appliance;
•
The outlet and electrical circuit are adequate for the appli-
ance;
•
The outlet is a 3-hole grounded outlet
the case, you must choose another outlet. Failure to follow
these important safety instructions absolves the manufac-
turer of all liability.
If it becomes necessary, the power cable must be re-
placed by a qualified professional only.
The instructions below will enable you to prepare your air
conditioner for operation as efficiently as possible. Before use,
make sure the air intake and outlet grilles are unobstructed.
USE
Note: This appliance features an auto evaporative
function to remove excess condensate water
during cooling and dehumidifiying modes.
CONDITIONING WITH INSTALLATION
For optimal results set-up your appliance in this way:
•
Fit the assembled air exhaust hose B2 in the housing at the
back of the appliance. Insert it as shown in figure 1.
1
•
Respect the distances given in figure 2.
2
min. 11.8 in
min. 30 cm
5
. If this is not
min. 11.8 in
min. 30 cm