Publicité
Les langues disponibles
Les langues disponibles
CLEANING
Before cleaning or maintenance, turn the appliance off by
touching the
button, wait a few seconds, then unplug from
the outlet.
CLEANING THE CABINET
You should clean the appliance with a slightly damp cloth then
dry with a dry cloth. For safety reasons, never wash the air con-
ditioner with water.
Precautions
Never use petrol, alcohol or solvents to clean the appliance. Nev-
er spray insecticide liquids or similar.
CLEANING THE BIO SILVER AIR FILTER
If the filter is dirty, air circulation is compromised and the ef-
ficiency of the dehumidifying and air purifying functions de-
creases.
It is therefore good practice to clean the filter at regular inter-
vals. The frequency depends on the duration and conditions of
operation.
If the unit is used constantly or systematically, you are recom-
mended to clean the filter once a week.
The filter is housed in the intake grille.
To clean the filter, extract as shown in fig. 8.
To maintain the efficiency of the air conditioner, it is recom-
mended to clean the dust filter after every week of use.
The filter is located near the intake grille. Remove the grille to
access the filter. To clean the filter, it will need to be extracted
as shown in fig. 8.
8
Use a vacuum cleaner to remove any dust deposited on the filter.
If it is very dirty, submerge it into warm water and rinse it several
times. The water temperature must be kept below 104° F (40°C).
After washing the filter, allow it to dry.
After washing the filter, allow it to dry completely before
repositioning it.
The BioSilver filter helps capture dust and pollen and helps re-
duce the growth of bacteria and mold on the filter.
CHECKS AT THE START OF THE SEASON
Make sure the power cable and socket are in perfect condition
and make sure the earthing system is efficient. Comply strictly
with the installation standards.
END OF SEASON OPERATIONS
To drain all water from the circuit, remove the cap A11 from the
drainage on the back of the appliance and allow the water to
drain out into a basin (fig. 9).
To facilitate this operation, at the start of the season, it's possible
to apply the water drain hose with cap B6.
In order to properly storage the appliance at the end of the sea-
son, we suggest you cover it with the supplied end of season
dust cover B8 and you put the accessories in the relevant end of
season accessories bag B9.
9
When the appliance is empty, replace the cap.
Clean the filter and dry thoroughly before putting back.
TECHNICAL SPECIFICATIONS
Power supply voltage
Max. absorbed power during air conditioning
Refrigerant
Cooling capacity
LIMIT CONDITIONS
Room temperature for
air conditioning
Room temperature for
heating
Transport, filling, cleaning, recovery and disposal of
refrigerant should be performed by a technical service
centre appointed by the manufacturer only.
The appliance should be disposed of by a specialist centre
appointed by the manufacturer only.
13
see rating label
"
"
"
64 ÷ 95°F (18° ÷ 35°C)
50 ÷ 77°F (10 ÷ 25°C)
Publicité
